EXTENSION HOUSING REAR OIL SEAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER NO.2

  1. Remove the 4 screws, 2 grommets, 2 spacers and under cover.



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


4. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(Click here)


5. DRAIN AUTOMATIC TRANSMISSION FLUID

  1. Remove the drain plug and gasket, and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



6. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


    C108485E01

  1. Using SST, remove the oil seal.

    SST
    09308-00010