TORQUE CONVERTER AND DRIVE PLATE > INSPECTION

for Preparation Click here

1. Inspect the one-way clutch.
   
   

   1. Install SST so that it fits in a notch of the converter hub and a notch of the outer race of the one-way clutch.
      

      SST

      09350-32014   (09351-32010, 09351-32020)
      

   2. Press on the serrations of the startor with a finger and rotate it.
      Check that it rotates smoothly when turned clockwise and locks up when turned counterclockwise.
      

      SST

      09350-32014   (09351-32010, 09351-32020)
      

      If necessary, clean the converter and retest the one-way clutch.
      Replace the converter if the one-way clutch still fails the test.
      

2. Determine the condition of the torque converter clutch assembly.
   
   

   1. If the inspection result of the torque converter clutch assembly meets the following item, replace the torque converter clutch.
      

      Malfunction Item:

      Any metallic sound is heard from the torque converter clutch during stall test or when the shift lever is in the N position.
      The one-way clutch is free or locked in both directions.
      Fine powder exceeding the sample limit is identified in ATF. (See the sample.)
      

      HINT:

      The sample shows approx. 0.25 liters (0.26 US qts, 0.22 lmp. qts) of ATF that is taken out from the removed torque converter clutch.

3. Replace the ATF in the torque converter clutch.
   
   

   1. If the ATF is discolored and/or has a foul odor, completely stir the ATF in the torque converter clutch and drain it with the installation face up.
      

4. Clean and check the oil cooler and oil pipe line.
   
   

   1. If the torque converter clutch is inspected or the ATF is changed, clean the oil cooler and oil pipe line.
      

      HINT:

      1. Spray compressed air of 196 kpa (2 kgf/cm^２, 28 psi) from the inlet hose.
         
      2. If a lot of fire powder is found in the ATF, add new ATF using a bucket pump and clean it again.
         

   2. If the ATF is cloudy, inspect the oil cooler (radiator).
      

5. Prevent deformation of the torque converter clutch.
   
   

   1. When there is any damage to the end of the bolt for the torque converter clutch and to the bottom of the bolt hole, replace the bolt and the torque converter clutch.
      

   2. All of the bolts have to be of the same length.