REAR PROPELLER SHAFT ASSEMBLY (for 3GR-FSE) > DISASSEMBLY

for Preparation Click here



1. REMOVE PROPELLER SHAFT ASSEMBLY


    C109591E01

  1. Put matchmarks on both flanges.



    C104520E01

  1. Remove the 4 nuts, bolts, washers and propeller shaft assembly.



2. REMOVE CENTER SUPPORT BEARING ASSEMBLY NO.1

  1. Hold the intermediate shaft assembly in a vise between aluminium plates.

    NOTICE:
    Do not overtighten the vise.



    C104524E01

  1. Using a chisel and a hammer, release the staked part of the nut.

    NOTICE:
    Release the staked part of the nut completely, otherwise the threads of the intermediate shaft may be damaged.



    C109592E01

  1. Using SST to hold the universal joint flange, remove the nut and intermediate shaft washer.

    SST
    09330-00021  



    C109593E01

  1. Put matchmarks on the intermediate shaft assembly and universal joint flange.



    C109594E01

  1. Using SST, remove the universal joint flange from the intermediate shaft assembly.

    SST
    09950-00020  
    09950-00030  

    NOTICE:
    Apply grease to the threads and tip of the SST center bolt before use.

  1. Remove the center support bearing assembly No.1 and 2 center support bearing washers from the intermediate shaft assembly.

  1. Hold the intermediate shaft assembly in a vise between aluminium plates.

    NOTICE:
    Do not overtighten the vise.



    C053246

  1. Using a screwdriver and a hammer, remove the sliding shaft dust cover.



3. INSPECT PROPELLER SHAFT ASSEMBLY


    C062537E01

  1. Using a dial indicator, inspect the runout of the propeller shaft.

    Maximum runout:
    0.8 mm (0.031 in.)

    NOTICE:
    The dial indicator must be set at a right angle to the center of the propeller shaft.

    HINT:
    If the shaft runout exceeds the maximum, replace the propeller shaft.



4. INSPECT INTERMEDIATE SHAFT


    C036277E01

  1. Using a dial indicator, inspect the runout of the intermediate shaft.

    Maximum runout:
    0.8 mm (0.031 in.)

    NOTICE:
    The dial indicator must be set at a right angle to the center of the propeller shaft.

    HINT:
    If the shaft runout exceeds the maximum, replace the intermediate shaft.



5. INSPECT SPIDER BEARING


    C025770

  1. Check that the spider bearing rotates smoothly.

  1. Check that there is no play in the spider bearing.

    HINT:
    If necessary, replace the intermediate shaft.



6. INSPECT CENTER SUPPORT BEARING ASSEMBLY NO.1


    C022188E01

  1. Turn the center support bearing by hand in the rotating direction. Check the center support bearing turns smoothly.

  1. Check that the seals are not cracked or damaged.

    HINT:
    If the center support bearing is damaged, worn, or does not turn smoothly, replace it.