FRONT AXLE HUB > INSTALLATION

for Preparation Click here

1. Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.
   

   Torque:

   69 N*m{ 700 kgf*cm , 51 ft.*lbf }

1. Using a dial indicator, check for looseness near the center of the axle hub.
   

   Maximum:

   0.05 mm (0.0020 in.)
   

   NOTICE:

   Ensure that the dial indicator is set at right angles to the measurement surface.

   If looseness exceeds the maximum, replace the bearing.
   

1. Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
   

   Maximum:

   0.05 mm (0.0020 in.)
   

   NOTICE:

   Ensure that the dial indicator is set at right angles to the measurement surface.

   If runout exceeds the maximum, replace the axle hub.
   

1. Align the matchmarks, and install the front disc.
   

   HINT:

   When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.

1. Install the brake caliper assembly to the steering knuckle with the 2 bolts.
   

   Torque:

   78 N*m{ 795 kgf*cm , 58 ft.*lbf }

   NOTICE:

   1. Do not twist the front brake hose when installing the front disc brake caliper.
      
   2. Make sure that there are no foreign objects or damage to the threads of the bolts.
      
   3. Do not overtighten the bolts because the steering knuckle is made of aluminum and may be damaged.
      

1. Connect the speed sensor connector to the speed sensor front.
   

   NOTICE:

   Do not twist the sensor wire.

Torque:

103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }