PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER NO.2


3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


4. REMOVE ENGINE UNDER COVER AIR GUIDE BRACKET


    C107691

  1. Remove the 2 bolts and engine under cover air guide bracket.



5. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
(Click here)


6. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    G029335

  1. Remove the nut and separate the floor shift gear shifting rod sub-assembly.



7. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY


    C102406

  1. Support the automatic transmission with a transmission jack.



8. SEPARATE ENGINE REAR MOUNTING MEMBER


    C101506E01

  1. Remove the 4 bolts and separate the engine rear mounting member.



    C101507E01

  1. Remove the 4 nuts and engine rear mounting member.



9. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C101486E01

  1. Disconnect the park/neutral position switch connector.



    C101496E01

  1. Remove the nut and transmission control shaft lever RH.



    C101516

  1. Using a screwdriver, pry out the lock washer.



    C080255

  1. Remove the lock nut and lock washer.



    C080256

  1. Remove the bolt and park/neutral position switch.