FLOOR SHIFT ASSEMBLY > ADJUSTMENT

for Preparation Click here



1. ADJUST SHIFT LEVER POSITION


    C110474

  1. Remove the nut and disconnect the shifting rod.



    C064305E01

  1. Turn the control shaft lever of the neutral start switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.

  1. Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.

    NOTICE:
    Do not push the shift lever too hard.

  1. After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.