FLOOR SHIFT ASSEMBLY > ADJUSTMENT

for Preparation Click here



1. ADJUST SHIFT LEVER POSITION


    C110474

  1. Remove the nut and disconnect the shifting rod.



    C064305E01

  1. Turn the control shaft lever of the park/neutral position switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.

  1. Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.

    NOTICE:
    Do not push the shift lever too hard.

  1. After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.