FLOOR SHIFT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FLOOR SHIFT ASSEMBLY


    C107755

  1. Install the floor shift assembly with the 4 bolts.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

  1. Connect the connector to the floor shift assembly.



2. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    G029335

  1. Install the floor shift gear shifting rod sub-assembly with the nut.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. ADJUST SHIFT LEVER POSITION


    C080252

  1. Remove the nut and disconnect the shifting rod.



    C064305E01

  1. Turn the control shaft lever of the neutral start switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.

  1. Move the shift lever to the N position and tighten the nut while lightly pushing the lever toward the R position.

    NOTICE:
    Do not push the shift lever too hard.

  1. After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.



5. INSPECT SHIFT LEVER POSITION

  1. When shifting from the P to the R position with the engine switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.

  1. Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position.
    If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.



6. INSTALL FRONT FLOOR HEAT INSULATOR NO.1

  1. Install the heat insulator No.1 with the 4 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



7. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)


8. INSTALL NO.2 CONSOLE BOX DUCT


    E107617

  1. Install the console box duct with the 2 clips.



9. INSTALL CONSOLE BOX


B106268

  1. Connect the connector.

  1. Install the console box with the 4 bolts and 2 screws.



10. INSTALL CONSOLE BOX REGISTER ASSEMBLY


B105635E04

  1. Attach the 4 clips to install the register.



11. REMOVE CONSOLE BOX PLATE


B105638E10

  1. Connect the connector.

  1. Attach the 4 clips to install the console box.



12. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B105636E10

  1. Attach the 4 clips and 3 claws to install the finish panel end.

  1. Install the screw.



13. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


B105637E08

  1. Attach the 3 clips and 3 claws to install the finish panel end.

  1. Install the screw.



14. INSTALL CONSOLE UPPER PANEL ASSEMBLY


B111908E02

  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



15. INSTALL FRONT CONSOLE UPPER PANEL GARNISH

  1. Attach the claws to install the garnish.



16. PERFORM INITIALIZATION
(Click here)