FLOOR SHIFT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH


B111912

  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



3. REMOVE CONSOLE UPPER PANEL ASSEMBLY


B110191

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01

  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH


B105637E06

  1. Remove the screw.

  1. Using a screwdriver, detach the 3 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


B105636E09

  1. Remove the screw.

  1. Using a screwdriver, detach the 4 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



6. REMOVE CONSOLE BOX PLATE


B105638E06

  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the console box plate and then disconnect the connector.



7. REMOVE CONSOLE BOX REGISTER ASSEMBLY


B105635E01

  1. Using a screwdriver, detach the 4 clips and remove the register.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE CONSOLE BOX


B106268

  1. Remove the 4 bolts and 2 screws.

  1. Remove the console box and then disconnect the connector.



9. REMOVE NO.2 CONSOLE BOX DUCT


    E107617

  1. Remove the 2 clips and console box duct.



10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


11. REMOVE FRONT FLOOR HEAT INSULATOR NO.1

  1. Remove the 4 nuts and front floor heat insulator No.1.



12. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    G029335

  1. Remove the nut and separate the floor shift gear shifting rod sub-assembly.



13. REMOVE FLOOR SHIFT ASSEMBLY

  1. Disconnect the connectors.



    C107755

  1. Remove the 4 bolts.

  1. Remove the floor shift assembly.