OIL PUMP > INSPECTION

for Preparation Click here



1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY


    D027954

  1. Using a dial indicator, measure the inside diameter of the oil pump body bushing.

    Maximum inside diameter:
    38.138 mm (1.5015 in.)

    If the inside diameter is greater than the maximum inside diameter, replace the oil pump body.



2. INSPECT STATOR SHAFT ASSEMBLY


    D027955

  1. Using a dial indicator, measure the inside diameter of the stator shaft bushing.

    Maximum inside diameter:
    Front side:
    21.527 mm (0.8475 in.)
    Rear side:
    32.03 mm (1.261 in.)

    If the inside diameter is greater than the maximum inside diameter, replace the stator shaft.



3. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY


    D027956

  1. Push the driven gear to one side of the body.

  1. Using a feeler gauge, measure the clearance.

    Standard body clearance:
    0.10 to 0.17 mm (0.0039 to 0.0067 in.)

    If the body clearance is greater than the standard clearance, check the drive gear, the driven gear and the pump body.



    D027957

  1. Using a feeler gauge, measure the clearance between the driven gear teeth and the drive gear teeth.

    Standard tip clearance:
    0.070 to 0.150 mm (0.0028 to 0.0059 in.)

    If the tip clearance is greater than the standard clearance, check the drive gear, the driven gear and the pump body.



    D001286

  1. Using a steel straight edge and a feeler gauge, measure the side clearance of both gears.

    Standard side clearance:
    0.03 to 0.05 mm (0.0012 to 0.002 in.)

  1. There are 7 different thicknesses for the drive and driven gears.

    Drive and driven gears thickness:
    Mark
    		Thickness
    0
    		10.736 to 10.742 mm (0.42268 to 0.42291 in.)
    1
    		10.743 to 10.749 mm (0.42296 to 0.42319 in.)
    2
    		10.750 to 10.756 mm (0.42323 to 0.42346 in.)
    3
    		10.757 to 10.763 mm (0.42350 to 0.42374 in.)
    4
    		10.764 to 10.770 mm (0.42378 to 0.42401 in.)
    5
    		10.771 to 10.777 mm (0.42405 to 0.42429 in.)
    6
    		10.778 to 10.784 mm (0.42433 to 0.42457 in.)

    If the side clearance is greater than the standard thickness, check the drive gear, the driven gear and the pump body.



4. INSPECT OIL PUMP DRIVE GEAR ROTATION


    D027962

  1. Make sure that the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter.