FLOOR SHIFT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION CONTROL SWITCH

  1. Connect the park/neutral position switch connector.

    Standard resistance:
    Shift Position
    		Tester Connection
    		Specified Condition
    S, "+" and "-"
    		3 - 7
    		Below 1 Ω
    Except S, "+" and "-"
    		↑
    		10 kΩ or higher

  1. Disconnect the transmission control switch connector from the shift lock control unit assembly.



    G028380E08

  1. Measure resistance according to the value(s) in the table below when the shift lever is moved to each position.