TRANSMISSION WIRE > INSTALLATION

for Preparation Click here

1. Coat a new O-ring with ATF and install it to the transmission wire.
   

2. Install the transmission wire with the bolt.
   

   Torque:

   5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

3. Connect the transmission wire connector.
   

1. Coat an O-ring of the ATF temperature sensor with ATF.
   

2. Connect the 9 connectors to the solenoid valves.
   

3. Install the 2 clamps with the 2 bolts.
   

   Torque:

   Bolt A:

   6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

   Bolt B:

   10 N*m{ 102 kgf*cm , 7 ft.*lbf }

4. Install the ATF temperature sensor and lock plate with the bolt.
   

   Torque:

   10 N*m{ 100 kgf*cm , 7 ft.*lbf }

1. Coat a new O-ring with ATF.
   

2. Install the O-ring.
   

3. Install the oil strainer with the 4 bolts.
   

   Torque:

   10 N*m{ 100 kgf*cm , 7 ft.*lbf }

1. Install the 3 magnets in the oil pan.
   

2. Install a new gasket, install the oil pan to the transmission case with the 20 bolts.
   

   Torque:

   4.4 N*m{ 45 kgf*cm , 39 in.*lbf }

1. Install the engine under cover air guide bracket with the 2 bolts.
   

   Torque:

   26 N*m{ 260 kgf*cm , 19 ft.*lbf }

1. Install the exhaust pipe No.1 support bracket sub-assembly with the 2 bolts.
   

   Torque:

   43 N*m{ 438 kgf*cm , 32 ft.*lbf }