NAVIGATION SYSTEM > Illumination for Panel Switch does not Come on with Tail Switch ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)
I038223E01

  1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes to ON or OFF according to the light control switch operation.

    OK:
    Light Control Switch
    		Display
    TAIL or ON
    		ON
    OFF
    		OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



NG
REPLACE MULTI-DISPLAY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE