NAVIGATION SYSTEM > Display does not DIM (Night Screen) with Tail Switch ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IMAGE QUALITY SETTING
I100191E02

  1. Enter the display adjustment screen by pressing the "DISP" switch.

  1. Turn the light control switch to TAIL.

  1. Check if "DAY MODE" on the display adjustment is ON.

    OK:
    "DAY MODE" is ON.



NG
Go to step 2
OK

TURN "DAY MODE" SETTING OFF 

2.CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)
I038223E01

  1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes to ON or OFF according to the light control switch operation.

    OK:
    Light Control Switch
    		Display
    TAIL or ON
    		ON
    OFF
    		OFF

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK

REPLACE MULTI-DISPLAY