REAR VIEW MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.CHECK AND CLEAR DTC |
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
| Symptom does not occur | A |
| Symptom occurs | B |
|
| ||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK CAN COMMUNICATION SYSTEM* |
| |||||
| 7.CHECK DTC |
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 8.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM |
| Result | Proceed to |
| Symptom does not appear | A |
| Symptom appears | B |
|
| ||||
| |||||
| 9.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Corresponding symptom does not exist | A |
| Corresponding symptom exists | B |
|
| ||||
| |||||
| 10.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW |
Terminals of ECU (Click here).
| |||||
| 11.ADJUST, REPAIR OR REPLACE |
| |||||
| 12.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|