POWER WINDOW CONTROL SYSTEM > INITIALIZATION

for Preparation Click here



RESET (INITIALIZE) POWER WINDOW REGULATOR MOTOR

NOTICE:
Resetting the power window regulator motor (initializing the pulse sensor) is necessary if: 1) the battery terminal cable is disconnected; 2) the power window regulator master switch, wire harness, power window regulator switch, window regulator, and power window regulator motor are replaced or removed/installed; 3) the DC/CUT or MPX-B fuses are replaced. If resetting is not performed, the (master) switch will not be able to operate the AUTO operation function, jam protection and remote UP/DOWN function.

  1. Turn the engine switch on (IG).

  2. Open the power window halfway by pressing the power window switch.

  3. Fully pull the switch up until the power window is fully closed and hold the switch for at least 1 second.

  4. Check that the AUTO UP/DOWN function operates normally.

    HINT:
    If the AUTO UP/DOWN function operates normally, reset operations are completed. If abnormal, perform the following 3 steps.

  5. Disconnect the cable from the negative (-) battery terminal for 10 seconds or more.

  6. Reconnect the cable.

  7. Perform the first 4 steps above.

HINT:
If the remote UP/DOWN function does not operate after conditions 1), 2), or 3) is satisfied, the power window regulator master switch may have a malfunction.