ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Remove the 7 clips and duct seal.



3. REMOVE ENGINE ROOM SIDE COVER LH


A105934E01

  1. Remove the 3 clips and side cover.



4. REMOVE ECM COVER


    A105290

  1. Remove the 3 bolts and ECM cover.

    NOTICE:
    1. Remove all water from on and around the ECM cover.
    2. Perform the inspection indoors to avoid rain.
    3. Be sure to prevent water intrusion to the ECM (connectors and screw parts).



5. REMOVE ECM


  1. Disconnect the ECM connectors.



      A105291E01

    1. Using a screwdriver, disconnect the connector holder.

    2. Disconnect the 6 ECM connectors.



    A105292

  1. Remove the 2 nuts and ECM from the ECM box.