HEATED OXYGEN SENSOR (for Sensor 2) > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A105304E02

  1. Using SST, install the sensor to the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).

  1. Pass the sensor connector through the floor panel and install the grommet.



    A108165E02

  1. Connect the sensor connector.

  1. Install the scuff plate.



2. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A105306E02

  1. Using SST, install the sensor to the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for not use without SST

    HINT:
    Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).

  1. Pass the sensor connector through the floor panel and install the grommet.



    A108166E02

  1. Connect the sensor connector.



3. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B105642E03

  1. Attach the 2 claws and 4 clips to install the side panel.



4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


B105637E08

  1. Attach the 3 clips and 3 claws to install the finish panel end.

  1. Install the screw.



5. INSTALL CONSOLE BOX PLATE


B105638E10

  1. Connect the connector.

  1. Attach the 4 clips to install the console box.



6. INSTALL CONSOLE UPPER PANEL ASSEMBLY


B111908E02

  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



7. INSTALL FRONT CONSOLE UPPER GARNISH

  1. Attach the claws to install the garnish.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.