VACUUM SWITCHING VALVE (for EVAP) > INSTALLATION

for Preparation Click here



1. INSTALL VACUUM SWITCHING VALVE (for EVAP)


A110868

  1. Install the VSV to the intake air connector.

  1. Connect the 2 hoses.

  1. Connect the connector with the clamp.



2. INSTALL ENGINE ROOM SIDE COVER RH


    A105933E01

  1. Install the side cover with the 2 clips and nut.



3. INSTALL COOL AIR INTAKE DUCT SEAL


    A105932E01

  1. Install the intake duct seal with the 7 clips.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.