VACUUM SWITCHING VALVE (for EVAP) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


    A105932E01

  1. Remove the 7 clips and duct seal.



3. REMOVE ENGINE ROOM SIDE COVER RH


    A105933E01

  1. Loosen the nut and remove the 2 clips and side cover.



4. REMOVE VACUUM SWITCHING VALVE (for EVAP)


A110868

  1. Disconnect the connector and clamp.

  1. Disconnect the 2 hoses.

  1. Remove the VSV from the intake air connector.