HEATED OXYGEN SENSOR (for Sensor 2) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH


B111912

  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



3. REMOVE FRONT ASH RECEPTACLE ASSEMBLY


B110191

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01

  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH


B105637E06

  1. Remove the screw.

  1. Using a screwdriver, detach the 3 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


B105636E09

  1. Remove the screw.

  1. Using a screwdriver, detach the 4 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



6. REMOVE HEATED OXYGEN SENSOR (for Bank 1)


    A106914E01

  1. Disconnect the sensor connector.

  1. Disconnect the grommet and pull the sensor connector out of the cabin through the floor panel.



    A105307E01

  1. Using SST, remove the sensor.

    SST
    09224-00010  



7. REMOVE HEATED OXYGEN SENSOR (for Bank 2)


    A106915E01

  1. Disconnect the sensor connector.

  1. Disconnect the grommet and pull the sensor connector out of the cabin through the floor panel.



    A105305E01

  1. Using SST, remove the sensor.

    SST
    09224-00010