EXHAUST PIPE > INSTALLATION

for Preparation Click here



1. INSTALL TAILPIPE ASSEMBLY


A100615E05

  1. Connect the 6 exhaust pipe supports to install the tailpipe.



2. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY


A109953

  1. Install the support bracket with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



3. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    A077857

  1. Using a vernier caliper, measure the free length of the compression spring.

    Minimum length:
    38.5 mm (1.516 in.)

    If the free length is less than the minimum, replace the compression spring.



    A109513E01

  1. Install a new gasket to the rear side of the front exhaust pipe.

    HINT:
    Using a plastic-faced hammer, uniformly strike the gasket so that the gasket and front exhaust pipe are properly fit.

    NOTICE:
    1. Be careful with the installation direction of the gasket.
    1. Do not reuse the gasket.
    1. To ensure a proper seal, do not use the tailpipe to force the gasket onto the front exhaust pipe.



    A106753

  1. Install 2 new gaskets and the exhaust pipe front ends to the exhaust manifold with the 4 bolts and 2 nuts.

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }

    NOTICE:
    Do not reuse the gaskets.

  1. Install the front exhaust pipe to the tailpipe with the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



4. INSTALL HEATED OXYGEN SENSOR

  1. Install the 2 sensors (Click here).



5. INSTALL FRONT FLOOR BRACE CENTER


A109952

  1. Install the floor brace with the 4 bolts.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }



6. CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.


7. INSTALL NO. 2 ENGINE UNDER COVER


8. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.