EXHAUST PIPE > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe.
  1. The exhaust pipe is extremely hot immediately after the engine has stopped.
  1. Confirm that the exhaust pipe has cooled down before removing it.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 2 ENGINE UNDER COVER


3. REMOVE FRONT FLOOR BRACE CENTER


A109952

  1. Remove the 4 bolts and floor brace.



4. REMOVE HEATED OXYGEN SENSOR

  1. Remove the 2 sensors from the front exhaust pipe (Click here).



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


A106753

  1. Remove the 4 bolts and 4 nuts.

  1. Disconnect the exhaust pipe front ends from the exhaust manifold and remove the 2 gaskets.

  1. Remove the 2 bolts, 2 compression springs, exhaust pipe and gasket.



6. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY


A109953

  1. Remove the 2 bolts and support bracket.



7. REMOVE TAILPIPE ASSEMBLY


A100615E06

  1. Disconnect the 6 exhaust pipe supports to remove the tailpipe.