IGNITION COIL > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION COIL


    B012294

  1. Connect a new ignition coil to the spark plug, attach the ignition coil to the cylinder head cover, and install the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the ignition coil connector.



2. INSTALL V-BANK COVER

  1. Install the V-bank cover with the 2 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



3. INSTALL NO. 1 AIR CLEANER INLET

  1. Install the air cleaner inlet with the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



4. INSTALL ENGINE ROOM SIDE COVER LH


    A110867E01

  1. Install the side cover with the 3 clips.



5. INSTALL ENGINE ROOM SIDE COVER RH


    A110866E01

  1. Install the side cover with the 2 clips and nut.



6. INSTALL COOL AIR INTAKE DUCT SEAL


    A110865E01

  1. Install the intake duct seal with the 7 clips.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


8. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.