IGNITION COIL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


    A110865E01

  1. Remove the 7 clips and intake duct seal.



3. REMOVE ENGINE ROOM SIDE COVER RH


    A110866E01

  1. Remove the nut, 2 clips and side cover.



4. REMOVE ENGINE ROOM SIDE COVER LH


    A110867E01

  1. Remove the 3 clips and side cover.



5. REMOVE NO. 1 AIR CLEANER INLET

  1. Remove the bolt and air cleaner inlet.



6. REMOVE V-BANK COVER

  1. Remove the 2 nuts and V-bank cover.



7. REMOVE IGNITION COIL


B012294

  1. Disconnect the ignition coil connector.

  1. Remove the bolt and pull out the ignition coil.