IGNITION COIL > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION COIL


    A107637E01

  1. Install the 6 ignition coils with the 6 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the 6 ignition coil connectors.



    A107636

  1. Connect the 2 wire harness clamps.



2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE


    A103953E02

  1. Install the air cleaner cap with air cleaner hose with the 4 clamps and hose clamp.

    HINT:
    Be sure to install the air cleaner assembly so that the screw part of the hose clamp is as shown in the illustration.



    A103949

  1. Install the VSV for EVAP to the air cleaner hose.



    A103948

  1. Connect the MAF meter connector and clamp to the air cleaner.



3. INSTALL NO. 2 VENTILATION HOSE


    A103947

  1. Connect the ventilation hose to the cylinder head cover with the clamp.



4. INSTALL V-BANK COVER


A103946

  1. Install the V-bank cover with the 2 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



5. INSTALL ENGINE ROOM SIDE COVER LH


A105934E01

  1. Install the side cover with the 3 clips.



6. INSTALL ENGINE ROOM SIDE COVER RH


A105933E01

  1. Install the side cover with the 2 clips and nut.



7. INSTALL COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Install the intake duct seal with the 7 clips.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.