IGNITION COIL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Remove the 7 clips and duct seal.



3. REMOVE ENGINE ROOM SIDE COVER RH


A105933E01

  1. Loosen the nut and remove the 2 clips and side cover.



4. REMOVE ENGINE ROOM SIDE COVER LH


A105934E01

  1. Remove the 3 clips and side cover.



5. REMOVE V-BANK COVER


A103946

  1. Remove the 2 nuts and V-bank cover.



6. REMOVE NO. 2 VENTILATION HOSE


    A103947

  1. Disconnect the ventilation hose from the cylinder head.



7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    A103948

  1. Disconnect the MAF meter connector.

  1. Disconnect the clamp from the air cleaner.



    A103949

  1. Disconnect the VSV for EVAP.



    A103950

  1. Disconnect the 4 clamps.

  1. Remove the hose clamp and air cleaner cap with air cleaner hose.



8. REMOVE IGNITION COIL


    A107636

  1. Disconnect the 2 wire harness clamps.



    A107637E01

  1. Disconnect the 6 ignition coil connectors.

  1. Remove the 6 bolts and 6 ignition coils.