REAR STABILIZER BAR > INSTALLATION

for Preparation Click here

1. Insert the rear stabilizer bar between the rear suspension member and exhaust tail pipe assembly so that the indication mark on the rear stabilizer bar is on the right of the vehicle.
   

2. Install the 2 stabilizer bushes rears and stabilizer brackets.
   

   NOTICE:

   Be sure to install the rear stabilizer bush so that the cutout faces the rear of the vehicle.

3. Install the rear stabilizer bar with the 4 bolts.
   

   Torque:

   32 N*m{ 326 kgf*cm , 24 ft.*lbf }

1. Install the stabilizer link assembly LH to the rear suspension No.2 arm and load sensing valve sensor bracket with the bolt and nut.
   

   Torque:

   27 N*m{ 275 kgf*cm , 20 ft.*lbf }

2. Install the rear stabilizer link assembly LH with the nut.
   

   Torque:

   89 N*m{ 908 kgf*cm , 66 ft.*lbf }

   NOTICE:

   Be sure to hold the stud bolt using a hexagon wrench (6 mm) in order to prevent it from turning.

HINT:

Use the same procedures for the RH side and LH side.

1. Install the differential No.2 support protector with the 2 nuts.
   

Torque:

103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }