REAR STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE DIFFERENTIAL NO.2 SUPPORT PROTECTOR


    G033363

  1. Remove the 2 nuts and the differential No.2 support protector.



3. REMOVE REAR STABILIZER LINK ASSEMBLY LH


    C104543E01

  1. Remove the nut, and separate the rear stabilizer link assembly LH from the rear stabilizer bar.

    NOTICE:
    Be sure to hold the stud bolt using a hexagon wrench (6 mm) in order to prevent it from turning.

  1. Remove the bolt, nut and the stabilizer link assembly LH.



4. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures for the RH side and LH side.



5. REMOVE REAR STABILIZER BAR


    G032808

  1. Remove the 4 bolts, 2 stabilizer brackets, 2 stabilizer bushes rear and rear stabilizer bar.