YAW RATE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE SENSOR


    G033530E03

  1. Install the yaw rate sensor with the 2 bolts.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. Do not damage the yaw rate sensor.
    2. Make sure that the yaw rate sensor is installed securely.

  1. Install the 2 wire harness clamps.

  1. Connect the yaw rate sensor connector.



2. INSTALL CONSOLE BOX NO.1 DUCT


    C105640E06

  1. Install the console box No.1 duct with the clip.



3. INSTALL CONSOLE BOX NO.2 DUCT


    C105641E06

  1. Install the console box No.2 duct with the 2 clip.



4. INSTALL CONSOLE BOX


B106268

  1. Connect the connector.

  1. Install the console box with the 4 bolts and 2 screws.



5. INSTALL CONSOLE BOX REGISTER ASSEMBLY


B105635E04

  1. Attach the 4 clips to install the register.



6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B105636E10

  1. Attach the 4 clips and 3 claws to install the finish panel end.

  1. Install the screw.



7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


B105637E08

  1. Attach the 3 clips and 3 claws to install the finish panel end.

  1. Install the screw.



8. INSTALL CONSOLE BOX PLATE


B105638E10

  1. Connect the connector.

  1. Attach the 4 clips to install the console box.



9. INSTALL FRONT CONSOLE UPPER PANEL ASSEMBLY


B111908E02

  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



10. INSTALL CONSOLE UPPER PANEL GARNISH FRONT

  1. Attach the claws to install the garnish.



11. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(Click here)


12. INSPECT VSC SENSOR SIGNAL
(Click here)