YAW RATE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE CONSOLE UPPER PANEL GARNISH FRONT


B111912

  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



2. REMOVE FRONT CONSOLE UPPER PANEL ASSEMBLY


B110191

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01

  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



3. REMOVE CONSOLE BOX PLATE


B105638E06

  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the console box plate and then disconnect the connector.



4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH


B105637E06

  1. Remove the screw.

  1. Using a screwdriver, detach the 3 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


B105636E09

  1. Remove the screw.

  1. Using a screwdriver, detach the 4 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



6. REMOVE CONSOLE BOX REGISTER ASSEMBLY


B105635E01

  1. Using a screwdriver, detach the 4 clips and remove the register.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE CONSOLE BOX


B106268

  1. Remove the 4 bolts and 2 screws.

  1. Remove the console box and then disconnect the connector.



8. REMOVE CONSOLE BOX NO.2 DUCT


    C105641E03

  1. Remove the 2 clips and the console box No.2 duct.



9. REMOVE CONSOLE BOX NO.1 DUCT


    C105640E03

  1. Remove the clip and the console box duct No.1.



10. REMOVE YAW RATE SENSOR


    G033530E03

  1. Disconnect the yaw rate sensor connector.

  1. Separate the 2 wire harness clamps.

  1. Remove the 2 bolts and yaw rate sensor.

    NOTICE:
    Do not remove the sensor from the bracket.