STEERING SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(Click here)


3. REMOVE PLACE FRONT WHEELS FACING STRAIGHT AHEAD

NOTICE:
When reconnecting the cable to the negative battery terminal after installing the steering sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative battery terminal.



4. REMOVE STEERING WHEEL COVER NO.2 LOWER


    C107319

  1. Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



5. REMOVE STEERING WHEEL COVER NO.3 LOWER


    C107318

  1. Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



6. REMOVE STEERING PAD


    C106869E01

  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    C106868

  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



7. REMOVE STEERING WHEEL ASSEMBLY
For 3GR-FSE (Click here)
For 3GR-FE (Click here)
For 3UZ-FE (Click here)


8. REMOVE STEERING COLUMN COVER
For 3GR-FSE (Click here)
For 3GR-FE (Click here)
For 3UZ-FE (Click here)


9. REMOVE SPIRAL CABLE SUB-ASSEMBLY WITH STEERING SENSOR


    C110477E01

  1. Disconnect the connectors from the spiral cable with steering sensor.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Disengage the 3 claws and remove the spiral cable with steering sensor.



10. REMOVE STEERING SENSOR


    F047949E03

  1. Disengage the claws and remove the steering sensor from the spiral cable sub-assembly with steering sensor.