STEERING GEAR > DISASSEMBLY

for Preparation Click here



1. FIX POWER STEERING LINK ASSEMBLY


    C105582E01

  1. Using SST, secure the power steering link assembly.

    SST
    09612-00012  

    HINT:
    Tape the SST before use.



2. REMOVE TIE ROD END LH


    C110352E01

  1. Put matchmarks on the tie rod end LH and the steering rack end sub-assembly.

  1. Loosen the lock nut, and remove the tie rod end LH and the lock nut.



3. REMOVE TIE ROD END RH

HINT:
Perform the same procedure as for the LH side.



4. REMOVE STEERING RACK BOOT CLIP

  1. Using pliers, remove the 2 steering rack boot clips.



5. REMOVE STEERING RACK BOOT NO.1 CLAMP


    C100983

  1. Using pliers and a screwdriver, remove the steering rack boot No.1 clamp (LH side) as shown in the illustration.

    NOTICE:
    Be careful not to damage the boot.

  1. Remove the RH side by using the same procedure as for the LH side.



6. REMOVE STEERING RACK BOOT NO.1

  1. Remove the 2 steering rack boot No.1.



7. REMOVE STEERING RACK END SUB-ASSEMBLY


    C100984E01

  1. Using a screwdriver and a hammer, unstake the RH and LH claw washers.

    NOTICE:
    Avoid any impact to the steering rack.



    C105533E01

  1. Using SST, remove the steering rack end sub-assembly (LH side) and the claw washer.

    SST
    09922-10010  

    NOTICE:
    Use SST 09922-10010 following the direction shown in the illustration.



    C105534E01

  1. Using SST, remove the steering rack end sub-assembly (RH side) and the claw washer.

    SST
    09922-10010  

    NOTICE:
    Use SST 09922-10010 following the direction shown in the illustration.

    HINT:
    Using SST, hold the rack and remove the steering rack end sub-assembly.