DTC    01-E2    ON / OFF Indication Parameter Error (DSP AMP)

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-E2
When command for ON / OFF control from master device has problem
Radio receiver assembly

INSPECTION PROCEDURE

1.CHECK RADIO RECEIVER ASSEMBLY

  1. Check that the malfunction disappears when the radio receiver assembly is replaced with a normal one.

    OK:
    Malfunction disappears.



OK
REPLACE RADIO RECEIVER ASSEMBLY
NG

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE