AIR CONDITIONING SYSTEM > CHECK MODE PROCEDURE

for Preparation Click here



LIST OF OPERATION METHODS
By operating each of the A/C control switches as shown in the diagram below, it is possible to enter the diagnostic check mode.

E106866E01


CHECK DLC3
The vehicle uses the ISO 15765-4 communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-03 and matches the ISO 15765-4 format.
E106867E04

HINT:
A103811E08
Connect the cable of the intelligent tester to the DLC3, turn the engine switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.

Symbol
(Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
CANH (6) - CANL (14)
HIGH-level CAN bus line
Engine switch off
54 to 67 Ω
CANH (6) - Battery positive
HIGH-level CAN bus line
Engine switch off
1 MΩ or higher
CANH (6) - CG (4)
HIGH-level CAN bus line
Engine switch off
3 MΩ or higher
CANL (14) - Battery positive
LOW-level CAN bus line
Engine switch off
1 MΩ or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Engine switch off
3 MΩ or higher