COMBINATION METER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE STEERING COLUMN COVER UPPER
For 3GR-FE (Click here)
For 3GR-FSE (Click here)
For 3UZ-FE (Click here)


3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


B105640E06

  1. Using a screwdriver, detach the 5 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the cluster finish panel and then disconnect the connector.



4. REMOVE COMBINATION METER ASSEMBLY


B105641

  1. Remove the 4 screws.

  1. Disconnect the connector and remove the combination meter.



5. REMOVE COMBINATION METER GLASS


B113500E01

  1. Using a screwdriver, detach the 2 claws and open the cover.

    HINT:
    Tape the screwdriver tip before use.



    B113499

  1. Disconnect the 3 connectors.



    B113501E01

  1. Detach the 7 claws and remove the glass.