DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL V-RIBBED BELT


    A109593

  1. Install the V-ribbed belt.

  1. While turning the belt tensioner counterclockwise, remove the bar.

    NOTICE:
    1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
    2. Check that the V-ribbed belt is properly set to each pulley.



    A107548E02

  1. If it is difficult to install the V-ribbed belt, perform the following procedure.

    1. Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.

      NOTICE:
      1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
      2. Check that the V-ribbed belt is properly set to each pulley.



2. INSTALL V-BANK COVER SUB-ASSEMBLY


3. INSTALL NO. 1 AIR CLEANER INLET

  1. Install the air cleaner inlet with the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



4. INSTALL COOL AIR INTAKE DUCT SEAL


A105932E01

  1. Install the intake duct seal with the 7 clips.