LIGHTING SYSTEM > Front Fog Light Circuit |

| 1.PERFORM ACTIVE TEST BY INTELLIGENT TESTER |
Select the item below in the Active Test, use the intelligent tester to generate a control command, and then check that the fog light illuminates.
| Item | Test Details | Diagnostic Note |
| Front fog light relay | Front fog light relay ON / OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT FUSE (FR FOG, FR CTRL-AM) |
Remove the FR CTRL-AM fuses from the engine room No. 2 relay block.
Remove the FR FOG from the engine room No. 2 junction block.
Measure the resistance of the fuses.
|
| ||||
| OK | |
| 3.REPLACE FOG LIGHT BULB (FRONT RH OR FRONT LH) |
Temporarily replace the fog light bulb with a new or normally functioning one.
Check that the bulb illuminates.
|
| ||||
| NG | |
| 4.CHECK WIRE HARNESS (ENGINE ROOM NO. 2 JUNCTION BLOCK - BATTERY) |
![]() |
Disconnect the 2E junction block connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| 2E-1 - Body ground | 10 to 14 V |
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (ENGINE ROOM NO. 2 JUNCTION BLOCK - BODY GROUND) |
![]() |
Disconnect the 2G junction block connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| 2G-6 - Body ground | Below 1 Ω |
| 2G-7 - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||