FRONT SEAT INNER BELT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT INNER BELT ASSEMBLY


B100947E01

  1. Install the seat belt with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    1. NOTICE:
      Do not overlap the anchor part of the seat belt and protruding part of the seat adjuster.

  1. Install the seat belt's wire harness clamp.

  1. Connect the connector.



2. INSTALL FRONT SEAT ASSEMBLY


    B110334E03

  1. Place the seat in the cabin.

  1. Connect the connectors under the seat.

  1. Operate the power seat switch knob and move the seat to the foremost position.

  1. Tighten the 2 bolts on the rear side of the seat.

    Torque:
    36.8 N*m{ 375 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the 2 bolts in the order indicated in the illustration.

  1. Operate the power seat switch knob and move the seat to the rearmost position.

  1. Tighten the 2 bolts on the front side of the seat.

    Torque:
    36.8 N*m{ 375 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the 2 bolts in the order indicated in the illustration.



3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    B109367E02

  1. Move the seat using the power seat switch knob so that the seat belt anchor bolt is revealed.

  1. Install the front seat outer belt anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Install the seat belt anchor cover cap.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.