CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE CONSOLE UPPER PANEL GARNISH FRONT


B111912

  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



3. REMOVE FRONT ASH RECEPTACLE ASSEMBLY


B110191

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01

  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



4. REMOVE INSTRUMENT PANEL FINISH LH PANEL END


B105636E09

  1. Remove the screw.

  1. Using a screwdriver, detach the 4 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



5. REMOVE INSTRUMENT PANEL FINISH RH PANEL END


B105637E06

  1. Remove the screw.

  1. Using a screwdriver, detach the 3 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



6. REMOVE CONSOLE BOX PLATE


B105638E06

  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the console box plate and then disconnect the connector.



7. REMOVE CONSOLE BOX REGISTER ASSEMBLY


B105635E01

  1. Using a screwdriver, detach the 4 clips and remove the register.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE CONSOLE BOX


B106268

  1. Remove the 4 bolts and 2 screws.

  1. Remove the console box and then disconnect the connector.



9. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


    C107063

  1. Disconnect the holder (with connectors).

  1. Remove the nut, 2 bolts and center airbag sensor.