FRONT AIRBAG SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE COOL AIR INTAKE DUCT SEAL


B106147

  1. Using a clip remover, remove the 7 clips and duct seal.



3. REMOVE FRONT BUMPER COVER

  1. Using a clip remover, remove the 2 clips.

    HINT:
    Put protective tape under the front fender.



    B109982

  1. Remove the 6 screws and 5 bolts.



    B106150E01

  1. Pull the bumper cover to detach the 3 claws on the LH side.

  1. Pull the bumper cover to detach the 3 claws on the RH side and remove the bumper cover.

  1. w/ Clearance sonar system:
    Disconnect the ultrasonic sensor connector.



4. REMOVE HEADLIGHT ASSEMBLY


B109718

  1. Disconnect the connector as shown in the illustration.



    B109717E01

  1. Remove the 3 bolts.

  1. w/ Headlight cleaner:
    Disconnect the headlight cleaner hose.

  1. Detach the claw and remove the headlight.



5. REMOVE FRONT AIRBAG SENSOR


    C106375

  1. Remove the 2 bolts and front airbag sensor from the body.

  1. Disconnect the connector.