DRIVER SIDE KNEE AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE FRONT DOOR SCUFF PLATE


B111627E01

  1. Using a moulding remover, detach the 5 claws and remove the scuff plate.



3. REMOVE FRONT DOOR OPENING TRIM COVER

  1. Using a moulding remover, detach the 3 claws and remove the trim cover.



4. REMOVE CONSOLE UPPER PANEL GARNISH FRONT


B111912

  1. Using a clip remover, detach the claws and remove the garnish.

    HINT:
    Tape the clip remover tip before use.



5. REMOVE FRONT ASH RECEPTACLE ASSEMBLY


B110191

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.



    B111908E01

  1. Using a screwdriver, detach the 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the ash receptacle and then disconnect the connector.



6. REMOVE INSTRUMENT PANEL FINISH PANEL END


B105636E09

  1. Remove the screw.

  1. Using a screwdriver, detach the 4 clips and 3 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the finish panel end.



7. REMOVE INSTRUMENT SIDE PANEL


B105642E01

  1. Using a screwdriver, detach the 2 claws and 4 clips, and remove the side panel.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE INSTRUMENT PANEL UNDER NO.1 COVER SUB-ASSEMBLY


B105644E01

  1. Remove the 2 screws.

  1. Detach the 2 claws.

  1. Remove the under cover and then disconnect the connector.



9. REMOVE INSTRUMENT PANEL SAFETY NO.1 PAD SUB-ASSEMBLY


B105646E04

  1. Using a screwdriver, detach the 8 clips and claw.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the hood lock control cable from the safety pad.

  1. Remove the safety pad.



10. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY


    C106895

  1. Remove the 4 bolts and driver side knee airbag assembly.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.