DRIVER SIDE KNEE AIRBAG ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

  1. Perform a diagnostic system check (Click here).



    C106388

  1. With the driver side knee airbag assembly installed on the vehicle, perform a visual check including the following:

    1. Cuts, minute cracks or marked discoloration on the driver side knee airbag assembly.



2. INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

  1. Perform a diagnostic system check (Click here).



    C107325

  1. With the driver side knee airbag aseembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the driver side knee airbag assembly with a new one:

    1. Cuts, minute cracks or marked discoloration on the driver side knee airbag assembly.
    2. Cracks or other damage to the connector.
    3. Deformation or cracks on the instrument panel reinforcement.

    CAUTION:
    For removal and installation procedures of the driver side knee airbag assembly. Be sure to follow the correct procedure.