CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)

HINT:
Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY".



3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the 2 clips.



  1. Remove the 9 bolts and curtain shield airbag assembly.


    C110480E01