INTAKE MANIFOLD > INSPECTION

for Preparation Click here



1. INSPECT INTAKE MANIFOLD SUB-ASSEMBLY UPPER


A106524

  1. Using a precision straightedge and feeler gauge, measure the surface contacting the intake manifold upper for warpage.

    Maximum warpage:
    0.10 mm (0.0039 in.)

    If the warpage is greater than the maximum, replace the intake manifold sub-assembly upper.



2. INSPECT INTAKE MANIFOLD SUB-ASSEMBLY LOWER


A106525E01

  1. Using a precision straightedge and feeler gauge, measure the surface contacting the cylinder head and intake manifold for warpage.

    Maximum warpage:
    0.15 mm (0.0059 in.)

    If the warpage is greater than the maximum, replace the intake manifold sub-assembly lower.