DYNAMIC RADAR CRUISE CONTROL SYSTEM > OPERATION CHECK

for Preparation Click here



INPUT SIGNAL CHECK
E107860

  1. Connect the intelligent tester to the DLC3.

  2. Check the cruise control main switch using the DATA LIST function in the intelligent tester (ON-OFF, CANCEL, SET / COAST, RES / ACC, and MODE).


INSPECT MODE SWITCH
E107861

  1. Turn the engine switch on (IG).



    2. E106786

  2. Turn the main switch ON. Then push the main switch to MODE for 1 second or more to change to constant speed mode. Check that "NORM" is indicated on the display.

    NOTICE:
    Do not push any other switches before pushing the main switch to MODE. If another switch is pushed, turn the main switch OFF and repeat the procedure above.

    HINT:
    If a malfunction is detected, turn the engine switch off and repeat the procedure above.


INSPECT STEERING PAD SWITCH

  1. Turn the engine switch on (IG).

  2. Turn the cruise control main switch ON.

  3. Turn ON the distance control switch of the steering pad switch.



  4. Check that the indication of the vehicle-to-vehicle distance, which is shown in the multi-information display on the combination meter, changes from long to middle to short in that order.


    E106787E01

    HINT:
    The indication is automatically set to long each time the engine is started.