THERMOSTAT > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE ENGINE UNDER COVER


B107493

  1. Using a clip remover, remove the 3 clips.

  1. Remove the 10 screws and under cover.



3. REMOVE COOL AIR INTAKE DUCT SEAL


B106147

  1. Using a clip remover, remove the 7 clips and duct seal.



4. REMOVE NO. 1 AIR CLEANER INLET

  1. Remove the bolt and inlet.



5. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap and reservoir cap.



  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A110173E02



6. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. Remove the 2 nuts and cover.



7. DISCONNECT RADIATOR HOSE OUTLET

  1. Disconnect the hose from the water inlet with thermostat.



8. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT


A094891E01

  1. Remove the 3 nuts, water inlet with thermostat and gasket.