REAR SEAT AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL REAR SEAT AIRBAG ASSEMBLY


    C107077E02

  1. Engage the 3 claws and install the rear seat airbag assembly.

  1. Install the 2 bolts. Be sure to tighten bolt A before tightening bolt B.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL REAR DOOR SCUFF PLATE


B111646E01

  1. Attach the 5 claws to install the scuff plate.

  1. Pull out the folded lip of the weatherstrip.



3. INSTALL REAR SEATBACK ASSEMBLY


B105948

  1. Place the seatback in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Install the seatback with the 4 bolts and 2 nuts.

    Torque:
    18.1 N*m{ 185 kgf*cm , 13 ft.*lbf }

  1. Install the 2 rear seat covers.

  1. Pass the 3 seat belts through and close the cap of the 3 rear seat shoulder belt guides.

  1. Install the floor anchor part with the bolt.



4. INSTALL REAR SEAT LH AND RH HEADREST ASSEMBLY


5. INSTALL REAR SEAT CUSHION ASSEMBLY


B105974E01

  1. Attach the seat cushion's 2 rear hooks to the seatback.

  1. Attach the seat cushion's 2 front hooks to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.

    NOTICE:
    When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM INITIALIZATION


8. INSPECT SRS WARNING LIGHT