REAR SEAT AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE REAR SEAT CUSHION ASSEMBLY


B105946E01

  1. Detach the seat cushion's 2 front hooks from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat for the other hook.

  1. Detach the seat cushion's 2 rear hooks from the seatback.

  1. Remove the seat cushion.



3. REMOVE REAR SEAT LH AND RH HEADREST ASSEMBLY


4. REMOVE REAR SEATBACK ASSEMBLY



B105947

  1. Using a screwdriver, detach the claws and remove the 2 rear seat covers.

    HINT:
    Tape the screwdriver tip before use.



    B105996E01

  1. Using a screwdriver, detach the claw to open the cap of the 3 rear seat shoulder belt guides.

  1. Remove the bolt and floor anchor part.



    B105948

  1. Remove the 4 bolts and 2 nuts.

  1. Remove the seatback.



5. REMOVE REAR DOOR SCUFF PLATE


B111629

  1. Detach the 5 claws and remove the scuff plate.



6. REMOVE REAR SEAT AIRBAG ASSEMBLY

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



    C107077E01

  1. Remove the 2 bolts.

  1. Disengage the 3 claws and remove the rear seat airbag assembly.