FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    C107050

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the front passenger side knee airbag assembly with the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL INSTRUMENT PANEL UNDER NO.2 COVER SUB-ASSEMBLY


B108847E02

  1. Connect the connector and clamp.

  1. Attach the 4 clips to install the under cover.



3. INSTALL INSTRUMENT SIDE PANEL


B105643E04

  1. Attach the 2 claws and 4 clips to install the side panel.



4. INSTALL INSTRUMENT PANEL FINISH PANEL END


B105637E08

  1. Attach the 3 clips and 3 claws to install the finish panel end.

  1. Install the screw.



5. INSTALL FRONT ASH RECEPTACLE ASSEMBLY


B111908E02

  1. Connect the connector.

  1. Attach the 9 clips to install the ash receptacle.



    B110192

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



6. INSTALL CONSOLE UPPER PANEL GARNISH FRONT

  1. Attach the claws to install the garnish.



7. INSTALL FRONT DOOR OPENING TRIM COVER

HINT:
Use the same procedures described for the LH side.



8. INSTALL FRONT DOOR SCUFF PLATE

HINT:
Use the same procedures described for the LH side.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. PERFORM INITIALIZATION


11. INSPECT SRS WARNING LIGHT